Fabrication and Cutting Blades: The Basics

« Back to Home

Why You Should Start Using Computerized Orbital Welding Instead Of Manual Labor In Your Shop

Posted on

If you run a shop or any kind of facility where welding takes place, you likely already have some best practices to ensure a safe work environment and to get the work done as efficiently as possible. But depending on what you are trying to weld, there might be a better way to get the job done and that's by investing in computerized orbital welding equipment instead of continuing with manual labor. Here's how this type of welding equipment might benefit your company and your customers.

A Computer Can Simply Do It Faster and That Will Decrease Production Time 

With computerized orbital welding, you can plan out the exact dimensions of the final product and figure out every step you need to take with the equipment to get to that destination. Once properly set up and configured, the equipment will put out finished weld after finished weld like clockwork. A computerized setup can simply work faster and more efficiently than any human. This means you'll get more welding done in the same amount of time, decreasing your production time for each weld while increasing your company's final yield at the end of the day. This could allow you to take on more projects and make more money as time goes on.

Computerized Orbital Welding Equipment Can Ensure Better Consistency With Every Weld

Beyond just getting it done faster, orbital welding equipment run by computer will also ensure a more uniform and consistent production process. Every part or final product that comes out of the machinery will be a perfect match to whatever dimensions or configuration you set it up to be. A master welder might be able to achieve similar results through manual labor, but a computer is likely going to be at least a little bit better. This will assist with quality control and ensure each weld meets your criteria as much as possible.

Reduce Your Labor Costs By Letting a Computerized Machine Handle Most of the Work

You will still need human workers to load materials and get the configuration setup. But once the welding begins, the computer takes over and the human workers can step back and simply wait to inspect whatever it is you are producing. This means you might be able to get the job done without as much labor costs. Yes, this type of welding equipment will cost money to get started with, but the savings in labor will recoup that investment and then put you ahead financially over time.

For more information, contact an orbital welding equipment seller in your area. 


Share